Prolimatech Ultra Sleek Vortex 14 Fan Wire Clip Set - MK-26 Series The Prolimatech Ultra Sleek Vortex 14 Fan Wire Clip Set - Armageddon Series is a 4 piece set of fan clips to mount a 140mm x 15mm Ultra Sleek Vortex Fan on a Armageddon Series heatsink. Prolimatech Ultra Sleek Vortex 14 Fan Wire Clip Set - Armageddon Series Using this extra fan clip a push pull configuration is easy to set up! Designed for any 38mm thick fan this is very handy to boost performance on even the best heatsink available.Ĭomes with two clips to hold one fan on the Megahalems. Outfit your Prolimatech Megahalems Intel CPU Heatsink with an extra fan. Prolimatech Megahalems Extra Fan Clips - 38mm Fan Using this extra fan clip a push pull configuration is easy to set up! Designed for any 120 mm x 25mm thick fan this is very handy to boost performance on even the best heatsink available.Ĭomes with four clips to hold up to two fans on the Armegeddon. Outfit your Prolimatech Armageddon Intel CPU Heatsink with an extra fan.

Prolimatech Armageddon ArmaClip Extra Fan Clips - 120mm x 25mm Fans Or, if I find the correct clips later, can I come back and install them after the sink has been in place for awhile? It is an Elkay sink, and I've found product listings for Elkay LK-363 Mounting Clips, but I'm not sure if that's what I'm looking for.Air Cooling CPU Heatsinks/Coolers Heatsink Fan Clips So my question is: Are the sink clips necessary? What happens if I leave them out? The sink will be held in place by its own weight and the caulk joint around the edge, so it's not like it's going to pop up out of the counter and wander away, right?

I am looking for clips that will accommodate a thicker counter, but haven't found the right stuff yet, and I'm on a timeline to install this sink. Lo and behold, the countertop assembly is going to be too thick for the sink clips. The sink is supposed to clip on to the whole assembly including the furring strips. The assembly will be 3/16' tiles over thinset, over 1/4' durock, over plastic membrane, over 13/16' plywood, with another layer of 13/16' strips holding the countertop up for installation of the v-cap. I am installing a stainless steel drop-in sink over a tile countertop. I've gotten lots of good info from you guys over the years, and I finally have a stumper I haven't found in the archives.

G clip sink mount